F12-3 Precise And Efficient Special-shaped Curve Edge Banding Machine

2.The control panel of the F12-3 curved edge banding machine has clear marks and a digital temperature controller. You can set the glue to be heated to a predetermined temperature, the timer breaks the edge banding strip, and the speed can be adjusted at will between the maximum value of the button.

3.The F12-3 curved edge banding machine has a higher gluing assembly. The gluing assembly uses high-temperature resistant bearings and sealing rings. It is glued on one side. The glue line is small and glue is saved. Enlarged Glue Pot with 2800ml capacity to avoid multiple add glue. Bearing-type pressure plate and extended button make it easy and intuitive to adjust the amount of glue to ensure uniform glue application.

4.The F12-3 curved edge banding machine has an upgraded cutter assembly with a compact structure and ultra-fast response, ensuring vertical cutting accuracy and cutting flatness.

5.The U-shaped groove limit of the F12-3 curved edge banding machine prevents the edge banding strip from regressing, and the tape will run smoothly without deviation. Quickly adjust the edge banding strip height to prevent the edge banding strip from rebounding and moving up and down, and ensure smooth tape feeding.

6.The F12-3 curved edge banding machine uses hot air assistance to heat the edge banding strip, soften the edge banding strip, and make the edge banding strip and the board adhere firmly.

7.The fitting roller of the F12-3 curved edge banding machine is adjusted left and right according to the width of the edge banding strip to prevent the edge banding strip from deflecting up and down. With the secondary auxiliary pressure roller, the edge banding strip and the board are pressed twice to increase adhesion. Connection firmness.

8.The F12-3 curved edge banding machine automatically sprays glue clearing device and has two glue clearing devices to avoid glue sticking on the laminating wheel and the pressing belt plate.

9.When the F12-3 curve edge banding machine is banding, the tape is cut off by the curve timer or foot pedal control, and the dual cylinders automatically cut off the tape.

10.Position the small white shaft of the F12-3 curved edge banding machine so that the suction plate  is parallel to the small white shaft. Remove the small white shaft and the suction plate can be directly fixed to the small sealing plate.