| Quantity: | |
|---|---|
1.Touch screen: intuitive operation and easy management, parameters can be adjusted quickly, plates can be continuously added at intervals of 3 seconds, with automatic recording function to avoid material waste caused by overproduction.
2.Automatic feeding device: side plate design is adopted to ensure stability and firmness during operation, and reduce material damage caused by vibration or offset.
3.Pressure beam: electric lifting pressure beam, the bottom beam adopts a widened and thickened design, with strict dimensional tolerances, which increases its load-bearing capacity and durability.
4.Milling unit:Standard diamond pre-milling cutter, high milling accuracy, strong wear resistance, reduced replacement frequency, smooth milling without burrs.
5.Glue pot: Large capacity, no-clean glue pot, avoid multiple glue additions, easy to clean and maintain.
Cutter: Automatic tape feeding and tape breaking, pneumatic cutter, stable cutting, good cutting flatness and verticality.
Pressing: Three-pass contour pressing to meet the pressing needs at different angles, making the edge banding more firmly pressed.
6.Flush head and tail:Quickly cut off the excess edge strips at both ends, and the two saw blades cooperate front and back to achieve high precision and high efficiency.
7.Profiling tracking:Upper and lower profiling tracking chamfering, making the rounded corners smoother and saving manual operation.
8.Edge scraping unit:Scrape off the excess edge banding materials and glue lines on the upper and lower sides of the board, making the upper and lower edges rounded, smooth and curved.
9.Polishing unit:Adding a glue cleaning device before polishing can better remove the residual glue lines on the board, making the edge banding strip round, smooth and clean.
10.Widening bar: After pulling it apart, it increases the compatibility of plates and facilitates the operation of large plates.
| Edge banding thickness | 0.8-2mm | Head and tail motor | 0.37KW*2 |
| Board thickness | 15-50mm | Rubber box heater | 2kw |
| Conveying speed | 15 m/min | Tracking motor | 0.75kw*2 |
| Conveyor motor | 1.5Kw32 shaft | Up and down polishing motor | 0.55KW*2 |
| Milling motor | 1.8KW*2 variable frequency speed regulation | Electric lifting motor | 0.37KW |
| Rubber box motor | 0.55kw | Total power | 11.36kw |
